Silver Night Anniversary PX25
Parallel single ended Mono-block Hard wired
Audion Silver Night Anniversary Parallel single ended PX25 mono-block is our intermediate level power amplifier, using the lesser known PX25 tubes. This amplifier is hand built and point to point hard wired using solid silver 5 *9's in some of the audio path. Wherever possible the components are sourced from Europe and the USA and avoiding inferior Chinese components.
This triode based mono-block amp uses no (zero) feedback in the design. The chassis is black powder coated aluminum as is the transformer cover. The top plate and badge are mirror finished stainless steel.
Amplifier matching
The PSE is often referred to as a data retrieval machine, we prefer to think that it is not too analytical, but very clean and musical and very transparent.
The Silver Night Parallel single ended amplifier comes with KR PX25's but can also be made with 300B or 2A3 tubes upon request. This amp is best suited for use with loudspeakers of 88db or better efficiency. Ideally matched with our range of Electron cables. The amps deliver 20 watts into 8 ohms from a PX25. Upgrade options are available for this model, see upgrade options at end.
Quality both inside and out
Having a volume control on the front and mono inputs on the rear means that a pre-amplifier is not necessary with this unit, but is advised . These amps are all auto biased. It will take almost any PX25 with a UX4 base(Unit is supplied with KR PX25 tubes).The Silver Night Anniversary Parallel single ended amplifier PX25 Class A power amplifier has 4 & 8 ohm outputs and mono inputs.
The Silver Night Parallel single ended amplifier is hard wired (Air Wired©) Class A mono-block power amplifier. It is built with components sourced from Europe and the US. Where possible we avoid the use of any Chinese component. Our output transformers are wound in-house to our exacting standards and many of the components are either made by us or specifically for us. We use KR PX25 and Russian New old stock 6H23N as a driver and input tubes. This amp is designed for power and musicality.
Power |
2 x 20 Watts Class A into 8 Ohms at 240V AC |
Load: |
4 & 8 Ohm Nominal |
Distortion @ 1Watt: |
<0.1% No Feedback |
Frequency Response: |
<10 – >40KHz±3 db |
Sensitivity: |
Variable >150mV Full output |
Noise: |
< (CCIR) – 90 db |
Consumption: |
174 Watts per mono |
Tubes: |
2 x PX25,
2 x 6H23N in each mono-block |
Size - |
42cm deep, 23cm tall and 19cm tall - Less tubes |
Weight |
11kgs per mono |
Fuses - |
Power 2A / 240V HT 500mA / 240V |
Warranty - |
2 years - tubes 6 months |
Read more about possible upgrades and options for this amp:
Upgrades and options